Subdividing plots - MDT25

5.2 Subdividing Plots

Zoom into plot 1, which has about 5,000 m² and we want to divide into 3 smaller plots. To do this, run Plots > Divide > Divide by Parallel.

Select plot 1 and then the start and end points of the South side.

Next, enter N (Number) as the method and enter the value 3.

Divide by Number/Area/:N

Number of plots <2>: 3

3 Plots created. Area 1677.040 m²

As can be seen, plot 1 has been deleted and plots 3, 4 and 5 have been created.

Zoom into plot 2 and run Plots > Divide > Divide by Facade Length. Select plot 2 and a point on the South side.

Press Enter to select the default mode (facade length) and enter a value of 20. 4 plots will be created.

Select plot

Select facade:

Number/:

Facade Length (Maximum:64.792):20

4 plot(s) created