Measurements report - MDT25

11.2 Measurements Report

Then, we will obtain some surface and volume lists that will be useful for the calculation of earthworks.

Run the command Quantity Takeoff> Areas> Cross-Section Measurement Report (or Quantity Takeoff> Roads> Areas> Cross-Sections Measurement Report) and select the SOLERA.SEG file. The calculation that we want to make relates to areas measured in plan. Hence, we select Areas and On ground plan options for the calculation type. We validate the dialog box.

Then, if our road has a defined roadbed, a window will appear where we must select the roadbed layer on which we want to carry out the measurement. In this case, only the grade line and subgrade will be displayed, because we have not defined any intermediate roadbed layer. We will select Grade line.

After that, a section by section report of the crown and slope areas of the road will be displayed.

Then, we obtain a list of the roadbed measurements, that is, band length, hard shoulder, road, etc. To do this, run the command Quantity Takeoff > Areas > Roadbed Measurements Report (or Quantity Takeoff > Roads > Roadbed Measurement List). Select the SOLERA.SEG file and validate the dialog box.

In this list, the volume of roadbed and reinforcement data are null because we have not defined them in our type section.