tcpMDT
In this section
- Insert images - MDT25This command lets you insert one or more georeferenced images into its coordinates in different formats, depending on the CAD and version…
- Insert photos with position - MDT25This command allows a group of images with EXIF^(1)^ information about their location to be selected and shows a dialogue in which a…
- Mode - MDT25In all subsequent commands it is requested to select an image and the selection of the name and the location of the resulting image is…
- Turn - MDT25In all the following commands it is requested to select an image and the selection of the name and the location of the resulting image is…
- Rotate - MDT25The georeference will be affected by all the operations involving any kind of rotation; in these cases, it will change the terms dependent…
- Adjust - MDT25In the dialogues described below the image is shown before and after applying the changes; in these image controls the images can be…
- Resize image - MDT25This shows information about the selected image such as the width and height in pixels, the horizontal and vertical resolution in pixels…
- Convert image format - MDT25This command allows you to convert from one image format to another. The image formats allowed in this command will be: JPG, ECW, JP2000…
- Delimit image - MDT25This command allows the selection of an image and a contour (closed polyline) and the creation of a new image with the area which…
- Cut image on sheets - MDT25This command allows the division of a georeferenced image on sheets, following as a standard a sheet scheme created with MDT using tools…
- Merge images - MDT25This command allows a group of georeferenced images to be merged in a single final image whose georeference will be calculated in line…
- Marks - MDT25To use the following commands, it is important to ascertain the following concepts: Marks: this is the name given to those blocks inserted…
- Identify image - MDT25This command allows the selection of an image and shows the file name on the text window so as to be able to identify it speedily from…
- Georeference image - MDT25In order to be able to use this command it is necessary to insert an image and have defined at least two Reference lines or Links. This…
- Reproject image - MDT25This command allows you to reproject an image inserted in the CAD, that is, to change its projection system. To do this, an image will…
- Save georeference - MDT25This command allows the creation of a Georeferencing file based on an image inserted in a drawing, already correctly situated in its…
- Distort image - MDT25In order to be able to use this command it is necessary to insert and image and have defined at least four Reference lines or Links. This…
- Exif information - MDT25This command shows whether the EXIF information which contains the selected image exists.