Creating network nodes - MDT25

20.1 Creating Network Nodes

First of all, we are going to create the nodes corresponding to the SEWERAGE network by executing the Pipe Networks > Create nodes from drawing command, after which a dialogue box will appear, which we will configure in accordance with the following screenshot. The depth of the node is important, and in this case, we are going to establish a depth of 3 meters. On checking the dialogue box, it will ask us for the name of the block, and we select SEWERAGE_MANHOLE.

The end result will be as follows, where we have deactivated the layer in which the image is located to make the work easier.

Next, we create the nodes for the rainwater network by executing the same command as in the previous case, but we now define a value of 2.5 for the depth and select RAINWATER_MANHOLE as the name of the rainwater block.