Calculate in elevation view - PV25

11.3 Calculate in Elevation View

This option will calculate in elevation the set of Fixed Structures previously converted with the "Convert Structures" command.

Based on the current surface area and the characteristics of the type of structure assigned, it will build the set of Fixed Structures and the earthworks associated with each of them, taking into account the following parameters.

In relation to the Area to which it belongs, the restrictions:

• Slope North South.

• East West slope.

Regarding the type of Fixed Structure, the parameters:

• Minimum ground clearance from the lowest end of the panel.

• Minimum and maximum height of each support.

• Panel tilt angle.

When executing this option, the software will request whether the calculation is going to be carried out on a specific Fixed Structure, all those existing in a Zone or the entire Project.

The software prioritizes the nominal clearance distance, i.e., that the distance between the lowest point of the plate and the final terrain is the value assigned to the nominal clearance.

From this value, the height of the poles is calculated looking for the minimum earth movement, based on their tolerances.

This process may take a few minutes depending on the size of the Project and the characteristics and restrictions associated with the Structures.

The software will look for the minimum earthwork taking into account the restrictions and parameters mentioned above.