Support
In this section
- Supported GNSS ReceiverstcpGPS includes a generic NMEA driver that allows one to connect to any GNSS receiver that supports this standard.The required NMEA…
- Supported Laser Distance MeterstcpGPS v2.10.0+. (1) Bluetooth Low Energy. The laser distance meter's Bluetooth radio must be turned on.
- How to connect Leica GNSS receivers with tcpGPS via Zeno Connect?tcpGPS v2.0+. Leica Zeno Connect v3.3.1.1.1647+. Leica GNSS receiver GG02, GG03, GG04, GG04 PLUS, FLX100, FLX100 PLUS or GS05. The Leica…
- How to configure EMLID Flow to use the tilt compensator of Reach RX2, RS3, RS4, and RS4 PRO receivers?Enable the tilt compensator. Enable NMEA output with the messages and frequencies shown in the following image: Although all messages are…
- What is NTRIP?The NTRIP protocol (acronym for Networked Transport of RTCM via Internet Protocol) is a standard used to transmit GNSS corrections, in…
- How to create an NTRIP profile?tcpGPS v2.0+. Not all brands and models support RTK configuration with NTRIP servers. Creating an NTRIP profile is only available if you…
- Device not shown in the Bluetooth listIf the receiver you intend to console with is not displayed on the Bluetooth device selection screen: Check that location is enabled and…
- How to connect a laser distance meter?To connect a laser distance meter in tcpGPS, the process is carried out via Bluetooth technology by following these steps: Connection…
- HiTarget / SatLab GNSS Receivers ConfigurationConfigure HiTarget and SatLab GNSS receivers to work in different modes, such as RTK and static. Hardware: Android device (tablet or…
- Configuration of EMLID receivers (ReachView)Note: this procedure uses the ReachView application, later replaced by EMLID Flow. Kept here as historical reference. Configure EMLID…
- Configuration of EMLID receivers with data collector (ReachView)Note: this procedure uses the ReachView 2 application, later replaced by EMLID Flow. Kept here as historical reference. Hardware: Android…
- Configuring tcpGPS for Android to work with EMLID Reach RS2/RS2+This tutorial shows how to configure TcpGPS to work with EMLID Reach RS2/RS2+ GNSS receivers in RTK mode, sending RTK corrections over the…
- Configuring tcpGPS for Android to work with EMLID Reach RXThis tutorial shows how to configure TcpGPS to work with EMLID Reach RX GNSS receivers in RTK mode, sending RTK corrections over the…
- Configuring tcpGPS for Android to work with EMLID Reach RS3This tutorial shows how to configure TcpGPS to work with EMLID Reach RS3 GNSS receivers in RTK mode, sending RTK corrections over the…
- Setting up CHCNAV LT700H for working in RTK modeSetting up the LT700H to work with TcpGPS in RTK mode connecting to CORS. Hardware: CHCNAV LT700H tablet. Software: TcpGPS v2.0+…
- Device Performance31/10/2023. Hardware: Android Device. Software: Android OS 7.0+, TcpGPS for Android 2.1+. This document is purely indicative and pretends…
- Which GNSS receivers is tcpGPS compatible with?Which GNSS receivers is it compatible with? The application is compatible with the main GNSS receivers on the market. To ensure that your…
- Can tcpGPS be used without an external receiver?Can TcpGPS be used without an external receiver? Yes, the application allows you to work without needing to connect to external receivers…