[PRO] earthworks by embankment head - MDT25

4.28 [PRO] Earthworks by Embankment Head

This command is equivalent to Earthworks by Terrain Elevation, with the peculiarity that only the platform and its slopes are generated where there is a fill volume. No cutting area is generated in the current surface.

An image of the original terrain is shown in the illustration below. It contains a highlighted polyline that defines the fill crown boundary desired.

If the outside of the area defined by the polyline is defined as the slopes' direction with an elevation of 595, the following result is obtained: From the polyline and starting from the elevation of 595, on one side a fill slope has been created and towards the other side a horizontal platform.