tcpMDT
In this section
- Setting Out. Introduction - MDT26A set of commands is described in this section that allow one to solve most setting out needs that may arise from the viewpoint of ground…
- [PRO] Analyze Points - MDT26Working mode. When the command is run, the command line asks for the working mode: Graphically/<Dialog>: Dialog (default option, chosen by…
- [PRO] Analyze of Points Between Roads - MDT26This command will make it easier for us to calculate the elevation difference between two roads at certain points that the user will…
- [PRO] Calculate Points by Station and Offset - MDT26This command helps one to calculate a point related to a horizontal alignment. The command initially requests if the values are to be…
- [PRO] label points on alignment - MDT26With this command we will be able to label marks in the drawing with the characteristics of the point with respect to the selected…
- [PRO] Set Out of Points - MDT26With this command, it is possible to calculate the coordinates of a set of points based on a previous selection made by the user. When the…
- [PRO] Set Out Simple Section - MDT26This command is used to easily set out a roadway without the need to define the segment fully. It would be ideal for setting out a section…
- [PRO] Elevations Report - MDT26This command generates a list of elevations of the vertices selected from the working segment. To do this the command initially requests…