Selection by point - PCE

7.2 Selection by Point

Location

• Ribbon menu
• Editing
  • SELECT
  • Selection by Point

Description

This command allows you to select points individually on the 3D viewer, one by one.

How to use

1. Use the mouse to designate the points to be selected on the 3D viewer.

2. Press the Backspace key or right-click + Undo to unmark the last point.

3. Once you have finished designating, press the Enter key or right click + Ok to select the designated points.

4. If you want to cancel the selection, press the ESC key or right click + Cancel.

Use cases

• Selection of isolated or noise points.

• Selection of distinguished points.