tcp PointCloud Editor
Selection by sphere - PCE
7.9 Selection by Sphere
Location
- Ribbon menu
- Editing
- SELECT
- Selection by Sphere
Description
This command selects all the points contained in a sphere.
The Selection by Sphere dialog will be shown. There you can set the center and radius of the sphere. Also, in the 3d viewer a sphere will be displayed. You can change the sphere parameters using the cone-shaped manipulators.
The points outside the sphere will be hidden while the selection is being made, to make it easier to see what is being selected.
Parameters
| Name | Meaning |
|---|---|
| Center X | The X-coordinate of the centre of the sphere. |
| Center Y | The Y-coordinate of the centre of the sphere. |
| Center Z | The Z-coordinate of the centre of the sphere. |
| Radius | Sphere radius. |