tcpMDT
Label Information in Profile - MDT26
Label Information in Profile
 | Command to execute in the CAD |
|---|---|
Vertical menu | MDT26 > Profiles > Drawing > Label information on Profile |
Ribbon menu | |
Command line |
Using this option, we can label the statio, elevation and slope of the designated point on the long section drawn beforehand.
With this in mind, upon executing the command, the following window will appear which is described below.
Direction: This allows us to indicate whether we wish to label the aligned texts horizontally or vertically.
Dimension: We indicate whether we wish to label the distances, the elevations or both.
Label Prefix: If we enable this box, in the case of the station, the text "Station:" will be labelled before the numerical value. and in the case of the elevation the text "Elevation:".
Text Height: We set the height to the texts to be drawn.
Decimals: We establish the number of decimal places both for the station and for the elevations.
A screenshot can then be seen of a profile drawing showing the station and the elevation labelled at different points.
