tcpMDT
Filter Points - MDT26
Filter Points
 | Command to execute in the CAD |
|---|---|
Vertical menu | MDT26 > Points > Edit Points > Filter Points |
Ribbon menu | Points > Edit > Filter |
Command line |
This utility allows one to delete points, or change layer of points, that are close to each other. The program requests the Minimum Distance that should exist between the points. Hence, any points that are at a lower distance than the one specified to another point are filtered. You can choose whether the distance is measured in 2D or 3D, and which is the point you want to keep, the higher or the lower one. The Check button is used to test the number of poinst by applying the filter.
In the Result section, you can choose to delete the points, or change their layer. If the latter option is enabled, the program then asks target layer for filtered points.